New Model with Current Indicator The POE-48-CI is an advanced 802.3af compliant power supply / power inserter. The power supply is autoranging on the input and has a regulated voltage output. It has overload and short circuit protection in addition to Ethernet surge suppression built-in. The POE-xxi is not a proprietary unit. It will function with any equipment which is compliant with the IEEE 802.3af POE standards. For all “i” models the power is supplied on ethernet pins 4/5 (V+) and 7/8 (V-). Current Indicator (-CI) modesl features an LED that will be AMBER until current flows to the end device which will turn the LED to GREEN. This is a good way to remotely monitor the connection between the POE and the end device and indicate that the end device is turned on.

Features

• "Carrier Class" Power Over Ethernet System
• 24VDC Auto Ranging Power Supply/ Inserter
• Reverse Polarity (Pins 4/5 V-, Pins 7/8 V+)
• Lightning/Surge Protected
• Advanced Auto-Sensing Algorithm
• Overload and Short Circuit Protection
• Minimum Cross Talk and Insertion Loss
• Advanced Switching Technology – Runs cool
• FCC and CE Approved
• Installation Schematic on Label

Description

The POE adapter gives "carrier class" performance in a low cost system.With its advanced auto-sensing algorithm it will supply power only to POE recognized end devices. This gives an added measure of protection against damaging equipment. The overload and short circuit protection will shut down power immediately when a short circuit is detected without any damage to the POE system. Typically in 100MB networks the maximum allowable CAT5 cable run is about 100 meters. This is not a limitation of the POE equipment but rather a limitation of the Ethernet standards. The POE-48-CI is not a proprietary unit. It will function with any equipment which meets the IEEE 802.3af POE standards (such as Routerboard 220/230's, Cisco IP Phones 79xx and many other units). Power is supplied on ethernet pins 4/5 (V+) and 7/8 (GND).